![]() This is because the bit on the right is the least significant and therefore always starts with it. Surely you have noticed that the order of the ports is the reverse of the order of the numbers and starts from the right. PCICR | = B00000100 // We activate the interrupts of the PD portĮasy, right? Well, as a bitwise operation, you can activate interrupts on several ports at the same time: PCICR |= B00000101 // We activate the interrupts of the PB and PD ports PCICR | = B00000010 // We activate the interrupts of the PC port ![]() Let’s go to the example: PCICR | = B00000001 // We activate the interrupts of the PB port To do this, we will simply have to perform a bitwise operation (if you don’t know what I’m talking about, you can go through this post to find out more). For this we will use the PCICR register, in which we will indicate on which port we want to activate the interrupts.ĭon’t be scared yet, using it is very easy. ![]() It is very important to know this, since to activate interrupts on a pin we will have to know which group it belongs to and activate the group. Finally we have the PD port, which corresponds to the group of pins PCINT16 to PCINT23, corresponding to digital pins D0 to D7.The second port we see is the PC, which corresponds to the group of pins PCINT8 to PCINT13, corresponding to pins A0 to A5.First we will find the PB port, which corresponds to the group of pins PCINT0 to PCINT5 and which are pins D8 to D13.In this diagram we can see the different groups of pins that there are, which are named as PB, PC and PD: To do this, the first thing we have to learn are the different groups of pins that there are, for which we can take a look at this image: In this first part we will learn how to activate each of the interrupt groups in order to use it. Port Registers That Will Trigger Interrupts (PCICR) ![]() Pin registers that will trigger interrupts (PCMSK).Register of ports that will trigger interrupts (PCICR).To understand it better, I will divide this guide into three parts: These will be activated whenever there is any change of state on the pin, either from HIGH to LOW, or from LOW to HIGH. Of course it has its disadvantages, and the main one is that you cannot indicate when to trigger the interrupt as you would with hardware interrupts. The advantages of PCINT interrupts are that you can use any pin on the Arduino to trigger them (which is quite useful). Earlier we talked about hardware interrupts (INT), which were limited to certain pins depending on the Arduino model. Today I am going to bring you something a little more advanced in Arduino, and it is the way to use PCINT Interrupts (Pin Changes interrupts), in Arduino. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |